Access Point Mode - TP-Link HC220-G1 User Manual

Chapter 2
• Method 3: Use the Sync button
Wireless devices that support WPS, including Android phones, tablets, most USB
network cards, can be connected to your Controller by this method.
Note:
• WPS is not supported by iOS devices.
• The WPS function cannot be configured if the wireless function of the Controller is disabled. Also, the WPS
function will be disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled
and is configured with the appropriate encryption before configuring the WPS.
1 ) Tap the WPS icon on the device's screen. Here we take an Android phone as an
example.
2 ) Immediately press the Sync button on your Controller.
3 ) The System Status LED flash for about two minutes during the WPS process.
Sync
2. 2. 2.

Access Point Mode

In the access point mode, your Controller and Satellites extend the wireless coverage
of your network.
Internet Ethernet1Ethernet2 Ethernet3
Ethernet2
Wired Router
1. Connect the power adapter to the Controller.
Close to
Ethernet4
WLAN
On
TP-Link
HomeNetwork
TP-Link_123
TP-Link_ABC
MyHome
Test
Controller
Connect the Hardware
Devices
9