5.
Access the live view and assign an IP address to the camera. For
details, see 10.1 Assigning an IP Address.
6.
Adjust angles of the camera body base on the live view. Three shafts
can be adjusted. See 4.4.2 Adjusting the Angles.
7.
Loosen the camera's cover, adjust the focus of the camera and insert
a micro SD card into the SD card slot. See 4.4.3 Adjusting Lens and
Inserting a Micro SD Card.
8.
Fasten the camera's cover.
9.
Install the sun-shield cover to the Bullet Camera. For details, see
4.4.4 Installing the Sun-Shield Cover.
4.4.1 Connecting the Camera
Wire Definition
The 7-Pin Data Cable provides connections for power, ground, 1 sensor
input, 1 alarm output, audio input and audio output. The wires are
illustrated and defined below:
Ethernet (PoE)
Figure 4-4
Bullet Camera
4
Digital In (Red)
DC 12V+ / AC 24V + (Brown)
Digital Out (Orange)
DC 12V- / AC 24V - (Black)
GND (Yellow)
Audio In (Red)
Audio Out (Green)
41