Port Configuration - Ruby Tech GS-2224L User Manual

3-2-1. Port Configuration

Port Configuration is applied to change the setting of each port. In this
configuration function, you can set/reset the following functions. All of them are
described in detail below.
Function name:
Port Configuration
Function description:
It is used to set each port's operation mode. The switch supports 3 parameters
for each port. They are state, mode and flow control.
Parameter description:
Speed:
Set the speed and duplex of the port. In speed, if the media is 1Gbps
fiber, it is always 1000Mbps and the duplex is full only. If the media is TP,
the Speed/Duplex is comprised of the combination of speed mode,
10/100/1000Mbps, and duplex mode, full duplex and half duplex. The
following table summarized the function the media supports.
Media type
1000M TP
1000M Fiber
In Auto-negotiation mode, no default value. In Forced mode, default
value depends on your setting.
Flow Control:
There are two modes to choose in flow control, including Enable and
Disable. If flow control is set Enable, both parties can send PAUSE frame
Fig. 3-12
NWay Speed
ON/OFF 10/100/1000M
ON/OFF 1000M
46
Duplex
Full for all, Half for 10/100
Full