Configuring Traffic Shaping On An Interface - Huawei Quidway S7700 Configuration Manual - Qos

Quidway S7700 Smart Routing Switch
Configuration Guide - QoS
shaping in an interface queue. Otherwise, traffic shaping fails. For example, traffic of lower
priorities preempts the bandwidth of traffic of higher priorities.
Pre-configuration Tasks
Before configuring traffic shaping, complete the following tasks:
l
l
Data Preparation
To configure traffic shaping, you need the following data.
No.
1
2
3

2.4.2 Configuring Traffic Shaping on an Interface

You can configure traffic shaping on an interface to limit the rate of data sent by the interface.
Context
To perform traffic shaping for all the downstream packets on an interface, perform this
procedure.
If you need to set the same traffic shaping rate on multiple interfaces, you can perform the
configuration on the port group to reduce the workload.
Do as follows on the S7700 where traffic shaping needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Or run the port-group port-group-name command to display the port group view.
Issue 01 (2011-07-15)
Setting link layer attributes of interfaces to ensure normal operation of the interfaces
Assigning IP addresses to the interfaces and configuring routing protocols to ensure that
routes are reachable
Data
Rate for traffic shaping on an interface
(Optional) Rate for traffic shaping in an interface queue, including the CIR and PIR
Interface on which traffic shaping is applied or index of the queue
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Traffic Policing and Traffic Shaping Configuration
59