Huawei Quidway S7700 Configuration Manual - Qos page 80

Quidway S7700 Smart Routing Switch
Configuration Guide - QoS
Figure 2-5 Networking diagram for configuring traffic shaping
PC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Create VLANs and configure interfaces.
# Create VLAN 10.
<Quidway> system-view
[Quidway] sysname Switch
[Switch] vlan batch 10
# Configure the type of GE 1/0/1 and GE 2/0/1 as trunk, and then add GE1/0/1 and GE2/0/1 to
VLAN 10.
[Switch] interface gigabitethernet1/0/1
[Switch-GigabitEthernet1/0/1] port link-type trunk
[Switch-GigabitEthernet1/0/1] port trunk allow-pass vlan 10
[Switch-GigabitEthernet1/0/1] quit
[Switch] interface gigabitethernet2/0/1
[Switch-GigabitEthernet2/0/1] port link-type trunk
[Switch-GigabitEthernet2/0/1] port trunk allow-pass vlan 10
[Switch-GigabitEthernet2/0/1] quit
Issue 01 (2011-07-15)
Phone
802.1p = 6
802.1p = 2
802.1p = 5
TV
Configure priority mapping based on simple traffic classification to map priorities of
packets to PHBs.
Configure traffic shaping on an interface to limit the bandwidth of the interface.
Configure traffic shaping in an interface queue to limit the CIRs of voice, video, and data
services.
802.1p priorities being 6, 5, and 2 mapped to PHBs
Rate for traffic shaping on an interface
Rate for traffic shaping in each interface queue
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Traffic Policing and Traffic Shaping Configuration
GE 1/0/1
LSW Switch
GE 2/0/1
Core
network
Router
73