Configuring Traffic Shaping On An Interface - Huawei Quidway S9300 Configuration Manual

2 Traffic Policing and Traffic Shaping Configuration
Pre-configuration Tasks
Before configuring traffic shaping, complete the following tasks:
l
l
l
Data Preparation
To configure traffic shaping, you need the following data.
No.
1
2
3

2.5.2 Configuring Traffic Shaping on an Interface

Context
To perform traffic shaping for all the downstream packets on an interface, perform this
procedure.
Do as follows on the S9300 where traffic shaping needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
qos lr cir cir-value [ cbs cbs-value ]
[ outbound ]
The rate for traffic shaping on an interface is set.
2-16
Setting link layer attributes of interfaces to ensure normal operation of the interfaces
Assigning IP addresses to the interfaces and configuring routing protocols to ensure that
routes are reachable
(Optional) Mapping packet priorities to PHBs (queue shaping on an interface) based on
simple traffic classification or re-marking the internal priorities based on complex traffic
classification For the configuration procedures, see
Based on Simple Traffic Classification
Complex Traffic Classification.
Data
Rate for traffic shaping on an interface
(Optional) Rate for traffic shaping in an interface queue, including the CIR and PIR
Interface on which traffic shaping is applied or index of the queue
NOTE
The interface type can be Ethernet, GE.
l
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - QoS
1.3 Configuring Priority Mapping
and 1.5 Creating a Traffic Policy Based on
Issue 03 (2009-08-20)