Example For Configuring Traffic Distribution Based On Ecmp - Huawei Quidway S7700 Configuration Manual - Qos

Quidway S7700 Smart Routing Switch
Configuration Guide - QoS

4.6.2 Example for Configuring Traffic Distribution Based on ECMP

Networking Requirements
As show in
The traffic sent from the upstream traffic splitter enters Switch A through XGE 2/0/1. Then the
traffic is distributed on four GE interfaces and sent to four packet analysis servers. It is required
that packets from the same source reach the same destination.
Issue 01 (2011-07-15)
classifier test behavior test
#
interface Eth-Trunk1
load-balance diffluence
#
interface GigabitEthernet1/0/1
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface GigabitEthernet1/0/2
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface GigabitEthernet1/0/3
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface GigabitEthernet1/0/4
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface XGigabitEthernet2/0/1
traffic-policy test inbound
#
return
Figure 4-4, Switch A is connected to the upstream traffic splitter through XGE 2/0/1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Traffic Distribution Configuration
107