Checking The Configuration; Configuring Traffic Distribution Based On Ecmp; Establishing The Configuration Task - Huawei Quidway S7700 Configuration Manual - Qos

Smart routing switch
Hide thumbs Also See for Quidway S7700:
Table of Contents

Advertisement

Quidway S7700 Smart Routing Switch
Configuration Guide - QoS
----End

4.3.5 Checking the Configuration

Prerequisite
The configurations of load balancing of the Eth-Trunk and the traffic policy are complete.
Procedure
l
l
l
l
l
l
----End

4.4 Configuring Traffic Distribution Based on ECMP

This section describes how to configure traffic distribution based on ECMP.

4.4.1 Establishing the Configuration Task

Applicable Environment
The traffic distribution device captures the packets and forwards them to a packet analysis device
or a computer that runs the packet analysis software for analyzing, recording and processing.
Because of the high link bandwidth on the backbone network, a packet analysis device cannot
analyze or process a large amount of traffic. Therefore, the traffic captured on the network cannot
be forwarded to the packet analysis device for analyzing and processing. In this case, a traffic
distribution device is required to distribute the traffic so that the host can process the distributed
traffic.
As shown in
Issue 01 (2011-07-15)
The traffic policy is applied to the inbound interface.
Run the display trunkmembership eth-trunk trunk-id command to check the member
interfaces of the Eth-Trunk.
Run the display interface eth-trunk [ trunk-id ] command to check the load balancing
mode of the Eth-Trunk.
Run the display traffic behavior user-defined [ behavior-name ] command to check the
configuration of the traffic behavior.
Run the display traffic classifier user-defined [ classifier-name ] command to check the
configuration of the traffic classifier.
Run the display traffic policy user-defined [ policy-name [ classifier classifier-name ] ]
command to check the configuration of the traffic policy.
Run the display traffic-policy policy-name applied-record command to check the
application of the specified traffic policy.
Figure
4-2, Switch A is the traffic distribution switch.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Traffic Distribution Configuration
100

Advertisement

Table of Contents
loading

Table of Contents