Safety Notices; International Safety Symbols - Extech Instruments MA61 User Manual

Safety
The product design meets IEC/EN61010‐1 and EN61010‐2‐033. Please read the User Guide
before use and comply with all safety instructions.
This product conforms to UL Standards 61010‐1, 61010‐2‐030, 61010‐2‐032, 61010‐2‐033 and is
Certified to CSA standards C22.2 no. 61010‐1, 61010‐2‐030 and IEC standards 61010‐2‐032 and
61010‐2‐033.
Safety Notices
1. Please use the clamp meter according to this User Guide otherwise the built‐in protections
may be compromised.
2. Please comply with with national safety regulations with regard to wearing personal
protective attire and gear to avoid injuray and damage caused by arc discharging in cases
where the live conductor is exposed.
3. Do not allow the fingers or the hand above the protective finger guard while testing.
4. Please check the clamp meter housing, buttons, switches, and insulated wires for cracks or
other damage before each use. Service or replace if necessary.
5. Please remove the clamp meter from all live circuits and disconnect the test leads before
removing the rear battery compartment cover.
6. Please do not use the clamp meter to measures signals greater than 600V or frequencies
higher than 400Hz.
7. Over‐voltage level: CAT II 600V; CAT III 300V, pollution class 2.
8. Working near exposed conductors must be done so using the highest caution. Such
conductors present a lethal electric shock hazard.
9. Use caution measuring voltage equal to or greater than 60VDC, 30VAC or 42V AC (peak) as
these present the risk of electric shock.
10. This device has a maximum measurement voltage limit of 600V and the safety standard
complies with CE/ETL certification (EN61010‐1, EN61010‐2‐033, and EN61010‐2‐032).
International Safety Symbols
3 MA61_MA63-en-GB_V1.0 3/15