Signet 8150 Manual page 14

14. Speed
SPEED averaging serves to smooth out À uctuations in the À ow rate that may be caused by inadequate straight pipe runs after pumps,
valves, and elbows in the pipe. The selections are 0, 7, 15, 30, 60 and 120 seconds. The factory standard setting is 30 seconds.
• Use faster (0-30 s) averaging for well-established, stable À ow conditions.
• Use slower (60-120 s) averaging if the À ow conditions are unstable.
Note: While the SPEED setting helps to smooth out the À uctuations caused by piping conditions, it also causes a delay in showing
actual changes in À ow rate. The SENSITIVITY function (section 15) is designed to help offset this effect.
Example: Change the SPEED setting from 60 seconds to 30 seconds.
1. Hold the ENTER key for 2 seconds, then enter the SECURITY CODE.
The display shows the ¿ rst item in the CALIBRATE menu, AutoCAL.
2. Press the DOWN key ¿ ve times to scroll to DISP SPEED.
The display shows DISP SPEED, the "sec" annunciator, and the current speed setting.
3. Press the RIGHT key to select the Display speed for editing.
The current speed selection begins À ashing.
4. Press the DOWN key one time to scroll from 60 seconds to 30 seconds.
5. Press the ENTER key to return to the menu.
6. Press UP and DOWN keys together to exit the menu and return to normal operation.
The display shows "Storing" for a few seconds, then returns to the normal operating display.
1
2
5x
6
**
* Exit Without Changing?
As long as any element is À ashing, you can abort
the change and return to the original value by
pressing UP and DOWN keys simultaneously.
14
ENTER
2 s
3
Enter Security code
4
*
Finished Editing?
**
Press the UP and DOWN keys
simultaneously from the main menu to
return to normal operation.
5
ENTER
8150 Flow Totalizer