Signet 8150 Manual page 13

13. Decimal Point for Flow Display
Select the maximum decimal resolution for the À ow rate display.
The available selections are hundredths (xx.xx), tenths (xxx.x) or
whole numbers only (xxxx.). The decimal will auto-range down to this
setting.
• If the decimal is set to whole numbers, the À ow rate display will
not auto-range.
• If the decimal is set to tenths, the À ow rate display will show
tenths up to 999.9, then the auto-range will switch to whole
numbers (1000 to 9999.)
• If the decimal is set to hundredths, the À ow rate display will show
hundredths up to 99.99, then tenths from 100.1 to 999.9, then
whole numbers to 9999.
Example: Change the maximum decimal display from
hundredths to tenths:
1. Hold the ENTER key for 2 seconds, then enter the SECURITY
CODE.
The display shows the ¿ rst item in the menu, AutoCAL.
2. Press the DOWN key four times to scroll to the Decimal setting.
The display shows four dashes and the current decimal setting.
3. Press the RIGHT key to select the decimal for editing.
The decimal point will begin to À ash.
4. Press the DOWN key one time to move the À ashing decimal
from hundredths to tenths.
1
2
4x
6
**
* Exit Without Changing?
As long as any element is À ashing, you can abort
the change and return to the original value by
pressing UP and DOWN keys simultaneously.
8150 Flow Totalizer
Available Display
Selections
hundredths (XX.XX)
tenths (XXX.X)
whole numbers (XXXX.)
5. Press the ENTER key to return to the menu.
The decimal will stop À ashing.
6. Press UP and DOWN keys together to exit the menu and
return to normal operation.
The display shows "Storing" for a few seconds, then returns
to the normal operating display.
ENTER
2 s
3
**
Your
Flow rate
10.55
10.55
10.55
Enter Security code
4 5
Finished Editing?
Press the UP and DOWN keys
simultaneously from the main menu to
return to normal operation.
will read
on display as:
10.55
10.6
11
*
ENTER
13