Furuno TZT9 Operator's Manual page 98

5. To change the name of the point, select [Name] to display the software keyboard.
Change the name as follows:
1) Select the character to edit. For example, "1" is selected in the following figure.
Alphabet software keyboard
Cursor
Select this to switch to the
numeric software keyboard.
2) Select an alphanumeric character from the software keyboard.
3) Repeat steps 1) and 2) to complete the name. A name can have a maximum
of 20 alphanumeric characters.
4) Select [Confirm].
6. To change the position, select [Position] to display the software keyboard. Set the
position referring to step 5.
N
7. Select [Color] to change the color of the point symbol.
8. Select a color.
9. Select [Icon] to change the point symbol.
10. Select a symbol.
11. Select [Comment] to display the software keyboard.
12. Enter the comment for the point.
13. Select [Confirm].
14. Select [Save].
15. Select [Close] to exit the menu.
Confirm
: Delete the character selected.
Del.
: Clear all characters.
Clr.
Cancel
Confirm
3
1 2 3
4 5 6
7 8 9
Clr
0
Select position format.
Numeric software keyboard
Cancel
•
"N" and "S" appear when the cursor is on
"N". When you select "W", "N" and "S" are
replaced with "E" and "W".
4. POINTS
Confirm
Select this to switch to the
alphabet software keyboard.
Confirm
1 2 3
4 5 6
7 8 9
0
Cancel
Cancel
Clr
•
4-9