Disposal; Manufacturer's Warranty - Tools - Hilti TE 706 Operating Instructions Manual

10. Disposal

Return waste material for recycling
en
Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be cor-
rectly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old power tools for recycling. Please ask your Hilti customer service department or Hilti representative
for further information.
Should you wish to return the power tool yourself to a disposal facility for recycling, proceed as follows: Disman-
tle the power tool as far as possible without the need for special tools. Use absorbent paper to wipe oily parts clean
and to collect any grease that runs out (total quantity approx. 50 ml). This paper must also be disposed of correctly.
On no account should grease be allowed to enter the waste water system or to find its way into the ground.
Separate the individual parts as follows:
Part/assembly
Toolbox
Gear housing
Bearing plate, flange
Grip, side handle
Casing
Motor casing, fan
Motor (rotor and stator)
Supply cord
Hammering mechanism parts
Screws, small parts
Dispose of the power tool in accordance with national regulations or return the used power tool to
Hilti.
11. Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5071189 / 000 / 00
Main material
Plastic
Aluminium alloy
Aluminium alloy
Plastic
Plastic
Plastic
Steel and copper
Copper, synthetic rubber
Steel
Steel
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
Recycling
Plastics recycling
Scrap metal
Scrap metal
Plastics recycling
Plastics recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
Scrap metal