Installing The Power Pack And Cell; Figure 4. Installation Requirements; Figure 5. Attaching The Power Pack; Figure 6. Disassemble Cell - Jandy APURE35 Installation And Operation Manual

3.3 Installing the Power Pack and Cell

To avoid property damage, serious injury or death, do not operate the electrolytic cell without water circulation. A buildup of
flammable gasses which can result in FIRE OR EXPLOSION.
1. Ensure placement of the cell and the power pack will meet all the installation requirements outlined in Section 3.2.
2. Screw the power pack bracket into position ensuring it is no more than 15 ft. (4.6 m) from the cell
(see Figure 4 and 5).
3. Position the power pack in place by aligning the bracket with the corresponding thru-holes (see Figure 5).
4. Wire the power pack to a power source and, if available, an AquaLink® RS Control System or PDA
(see Sections 3.4 - 3.6).
5. Unscrew the locking ring from the cell in order to extract it from the upper clamp (see Figure 6).
6. Press the two (2) push-buttons on either side of the upper clamp to separate the upper clamp from the lower clamp
(see Figure 6).
15 ft (4.6 m) MAX
Figure 4. Installation
Requirements
7. Invert the lower clamp and place on the pipe. Mark the pipe for drilling the feeder holes (see Figure 7).
8. Drill the feeder holes using the holesaw provided. Ensure holes are clean and smooth (see Figure 8).
9. Use the pipe spacer as shown if mounting on a 1½ in. (40mm) pipe (see Figure 9).
NOTE: The pipe spacer is required for 1 ½ in. (40mm) diameter pipe only. The spacer is not required on
2 in. (50 mm) pipe.
Figure 7. Marking Pipe for
Drilling Feeder Holes
WARNING
Screws
Figure 5. Attaching the Power Pack
Figure 8. Drilling Feeder Holes
Thru-holes
Figure 6.

Feeder Holes

Figure 9.
Page 11
Upper
Clamp Push-button
Lower
Clamp
Disassemble Cell
Spacer used for 1 ½ in
(
40mm) pipe only
Pipe Spacer