Placement Of Optional Logs - Monessen Hearth AVFL60NIP Installation Manual

Figure 7.5– Stone Placement
F. Placement of Optional Logs
WARNING: Turn off fireplace and allow to cool com-
pletely before beginning installation.
Kit Contents:
• Three driftwood logs
• Support pin brackets
• #8 bracket mounting screws
NOTE — Do not handle logs with your bare hands. Always
wear gloves to prevent skin irritation from logs. After
handling the logs, wash your hands with soap and water
to remove any traces of fibers.
NOTE: Prior to installing the log set, you must first install the
pin brackets on the burner. Fireglass and the air deflection
glass should only be installed after the pin brackets are in
place. The logs must then be placed in the unit after the
fireglass and air deflection glass. If the optional logs are
added after the air deflection glass and fireglass are in use,
move the fireglass away from the areas in Figure 7.6 and
install the support brackets, then arrange fireglass evenly
across burner again.
Figure 7.7– Pin Placement for Accessory Logs
24
PIN PLACEMENT FOR
REAR LOGS
REAR
FRONT
Monessen • AVFL60 Installation Manual • 4605-901 Rev. A • 05/17
WARNING
The positioning of the logs is critical to the safe
and clean operation of this heater. Sooting and
other problems may result if the logs are not
properly and firmly positioned in the appliance.
Never add additional logs or embellishments
such as pine cones, vermiculite or rock wool to
the heater. Only use the logs supplied with the
optional log kit (AVFL60DLS).
Failure to position the parts in accordance with
diagrams below or to use only parts specifically
approved for this heater may result in property
damage or personal injury.
1. Mount the four log support pin brackets using mount-
ing holes and screws provided in locations indicated
in Figure 7.7.
2. Place the large rear log (#1) by aligning the holes in
the bottom of each log with the four pins at the back
of the burner. Logs are marked "Rear Left" and "Rear
Right" for easy identification.
Figure 7.6– Log Pin Assembly
AIR DEFLECTION
GLASS