Placement Of Optional Logs - Monessen Hearth ARTISAN Series Installation Manual

E. Placement of Optional Logs
WARNING
The positioning of the logs is critical to the safe
and clean operation of this heater. Sooting and
other problems may result if the logs are not
properly and firmly positioned in the appliance.
Never add additional logs or embellishments
such as pine cones, vermiculite or rock wool to
the heater. Only use the logs supplied with the
optional log kit (CDLS).
Failure to position the parts in accordance with
diagrams below or to use only parts specifically
approved for this heater may result in property
damage or personal injury.
WARNING: Turn off appliance and allow to cool com-
pletely before beginning installation. DO NOT use this
kit with any other internal hearth option such as stones.
Kit Contents:
• Three (3) driftwood logs
• Six (6) log support pin brackets
• Six (6) #8 bracket mounting screws
Figure 7.5– Log Pin Placement for AVFL42N(P)IP-BU, AVFL42N(P)IP-RB, AVFL48N(P)IP, AVFLST48N(P)IP, ODLANAIG-48 AND ODLANAIGST-48
32
Log Pin Locations
Monessen • AVFL Series Installation Manual • 4099-901 Rev. A • 03/21
NOTE: Do not handle logs with your bare hands. Always
wear gloves to prevent skin irritation from log material.
After handling the logs, wash your hands with soap and
water to remove any traces of fibers.
NOTE: Prior to installing the log set, you must first install
the pin brackets on the burner. The air deflection glass and
glass media should only be installed after the pin brackets
are in place. The air deflection glass should be installed
prior to placing glass media on the burner. The logs must
then be placed in the unit after the glass media and air
deflection glass. If the optional logs are added to the appli-
ance after installation of deflective glass and glass media,
move the glass media away from the pin location holes
on the firebox bottom assembly as per Figure 7.5 or 7.7.
AVFL42N(P)IP-BU, AVFL42N(P)IP-RB, AVFL48N(P)IP,
and AVFLST48N(P)IP
1. Mount the four log support pin brackets using mount-
ing holes and screws provided in locations indicated
in Figure 7.5 for the front and rear log. Only one hole
of the pin bracket will be used to secure the pin to the
outside of the burner assembly base. The other hole
remains unused and rests on the mesh area. Next,
arrange glass media evenly across the burner again.