Table of Contents
Advertisement
AVFL Vent Free Fireplace
PLACEMENT OF OPTIONAL LOGS
WARNING: Turn off fireplace and allow to cool com-
pletely before beginning installation.
Kit Contents:
• Two (2) ceramic fiber driftwood logs
• Four (4) log support pin brackets
• Eight (8) #8 bracket mounting screws
NOTE — Do not handle logs with your bare hands. Always
wear gloves to prevent skin irritation from ceramic fi-
bers. After handling the logs, wash your hands with soap
and water to remove any traces of fibers.
NOTE: Prior to installing the log set, you must first install the
pin brackets on the burner. Fireglass and the air deflection
glass should only be installed after the pin brackets are in
place. The logs must then be placed in the unit after the
fireglass and air deflection glass. If the optional logs are
added after the air deflection glass and fireglass are in use,
move the fireglass away from the areas in Figure 17 and
Figure 18 –
Alternative Log Placement
Monessen • AVFL42NTSC-SR Installation Instructions • 4116-900 Rev. B • 10/19
20
Figure 16–
Stone Placement
install the support brackets, then arrange fireglass evenly
across burner again.
1. Mount the four log support
2. Place the large rear log
Pin placement
Log #1 (Rear)
Pin placement
Log #2 (Front)
Option 1
The positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only
use the logs supplied with the optional log
kit (AVFL42DLS).
Failure to position the parts in accordance
with diagrams below or to use only
parts specifically approved for this
heater may result in property damage or
personal injury.
pin brackets using mount-
ing holes and screws pro-
vided in locations indicated
in Figure 18. Note that the
front log can be mounted
in two different positions.
The pin brackets can be
moved to accommodate
the preferred log place-
ment.
(#1) by aligning the holes
in the bottom of the log
with the two pins at the
back of the burner. Figure 19.
Pin placement
Log #2 (Front)
Option 2
FINAL INSTALLATION
Figure 17 –
Log Pin Assembly
Air Deflection
Glass
Advertisement
Table of Contents
Troubleshooting
