Table of Contents
Advertisement
7
Final Installation
A. Dome Light Bulb Installation
Turn OFF the main power supply before perform-
ing any service work on the unit, including install-
ing or replacing light bulbs.
NOTE: This unit is shipped without bulbs installed to pre-
vent any damage to the bulb filament during transport. This
unit is shipped with a total of two (2) 90W bulbs.
Dome Light Bulb Installation
Figure 7.1– Dome Light Position
1. Remove three screws holding the left dome light
cover in place. See Figure 7.2.
Figure 7.2– Dome Light Screws
2. Insert (1) bulb provided into socket
3. Replace dome light cover with three screws
4. Repeat on right side light cover
22
TOP LIGHT LOCATION
Light cover
screws
Monessen • AVFL60 Installation Manual • 4605-901 Rev. A • 05/17
B. Black Magic Glass Installation
The Black Magic Glass liner is packaged and shipped
with the unit. Before install, remove the glass panels and
place on a flat, clean surface and inspect for damage.
NOTE: Before beginning installation remove the two L
shaped brackets from the manual pack along with two #8
phillips head screws.
NOTE: After gas and electric are connected and the unit
has been test fired the glass can be installed.
1. Place the rear glass panel against the rear wall of the
firebox, resting on top of the engine base. The dimples
in the glass will face the firebox.
2. Place the left side panel between the engine base
and firebox, resting on the botton of the firebox ledge.
Secure with supplied L bracket to the top of the firebox
witht the supplied screw.
3. Repeat step 2 on the right side.
NOTE: When removing the black glass from the unit, be
cautious of the rear panel falling forward once the side
panels are removed.
Figure 7.3 Black Magic Glass Installation
- Quick Links:
- Accessories
Hide quick links:
Advertisement
Table of Contents
