Installing Non-Combustible Facing Material - Monessen Hearth AVFL60NIP Installation Manual

Setting the Fireplace into the Framing
The left and right nailing tabs were designed as a means
to ensure the fireplace is mounted flush with the framing
materials. See Figures 4.2 and 4.3.
1. Bend out all nailing tabs. The AVFL60 has four nailing
tabs, two on each side in the middle of the unit.
2. Screw each nailing tab to the adjoining framing ma-
terial. See Figures 3.1-3.7 for framing and clearance
details.
Figure 4.3 Nailing Tabs
Monessen • AVFL60 Installation Manual • 4605-901 Rev. A • 05/17
B. Installing Non-Combustible Facing Material
WARNING! Risk of Fire!
• Follow these instructions exactly.
• Facing materials must be installed properly to prevent
fire.
• No materials may be substituted without authorization
by Hearth & Home Technologies.
• Non-Combustible facing material needs to be at least 6"
high and the full width of the unit.
• Attach non-combustible facing material to the framing
members with regular sheetrock screws.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• See Section 8 for finishing materials guidelines.
Figure 4.4 Install Non-Combustible Facing Material
13