Final Installation; Rockwool Placement; Log Placement - Monessen Hearth BDV300 Instruction Manual

FINAl INstAllAtIoN

RocK Wool plAceMeNt
1. Place rock wool on burner to provide glowing embers.
For best results, pull the rock wool apart into pieces
the size of a dime or smaller.
. Distribute one layer of rock wool to cover the burner.
Figure 60
3. Place the logs on the burner. Refer to Log Placement
below. Light unit and after 15 minutes, check burner
flame and glow. Refer to Burner Flame, Page 49.
If the flame is blue and only in the center, turn off unit
and let cool. After unit cools, remove logs. If the back
holes are clear, add more rock wool to the center of the
burner. Replace logs and check flame again. Save left
over rock wool to refresh when cleaning later. Too much
rock wool can disturb the flame and cause sooting on
the glass or logs.

loG plAceMeNt

1. Place rear log (#1) on grate assembly. Log should
rest firmly on the two log mounting pins on the
bars. Figure 61
. Place bottom left log (#) on grate. Rest the back
side of the log in the flat area of the rear log. Figure
61
3. Place bottom right log (#3) on grate. Rest the
back side of the log in the flat area of the rear log.
Figure 61
4. Place the top log (#4) on the rear log. Nest the
forked end of the top left log into the fork or the
rear log. Rest the narrow end of the top on the
vertical grate bar. Figure 61
lAVA RocK AND eMBeRs plAceMeNt
Sprinkle lava rock on the floor of the inner combustion
chamber. Evenly distribute the rock. Do not pile the lava
rock up in front of grate. Do not place lava rock on the
burner. If desired, purchase optional embers to decorate
the floor of the fireplace.
Do not sprinkle the lava rock or ember
chunks on top of the burner. this may cause
potential sooting, glass breakage and a fire
hazard.
54D0700
BDV Series Direct Vent Gas Fireplace
Cover with
Rock Wool
Figure 60 -
Placement of Rock Wool on Burner
FP2105
BDV base
Do not use the entire bag of rock wool
to cover the burner. this could cause
the flame to burn poorly and may lead to
sooting.
Top Left
Log #3
Rear Log
#1
Log Mounting
Pins
Left Vertical
Grate Bar
Center Vertical
Grate Bar
Figure 61 -
Log Placement
(BDV300 & BDV400 Shown)
LG619
Burner
FP105
Top
Right
Log #
Flat
Area
LG619
Right Vertical
Grate Bar
45