Recalling Scenes (Add Mode); Erasing Scenes - Elation SHOW DESIGNER 1 User Manual

S C E N E S [ c o n t i n u e d ]

RECALLING SCENES (add mode)

If you prefer that any unused channels in the scene remain as they are and not
fade to 0, you can operate scene playback in "add mode". In add mode,
channels that are not part of the new scene will be left in their current positions
and any chases that were running will keep running as long as the channels in the
chase are not used by the new scene. This method of playback allows channels
from previous scenes to track through to the next scene as long as the new scene
doesn't use those channels. This is also sometimes referred to as pile on mode.
You can turn add mode on by holding down the add switch when pressing the
scene mode switch. Do this when the scene mode LED is off. To turn add mode off,
press the scene mode switch while holding the erase switch. The "add mode" state
is backed up in memory so you only need to set it one time if you intend to always
use it this way.
NOTE: You cannot use add mode to combine scenes and then record the
combined scenes as a new larger scene.

ERASING SCENES

To erase a scene from memory, press, "RECORD" then "SCENE" then "ERASE". All
number LEDs that contain a scene will light. Next select the scene number to erase.
That scene name will appear in the LCD along with the message "Erase This?".
Press "YES" or "NO". If you press "YES" the scene will be erased. You can then select
additional scenes to be erased or you can press "RECORD" to exit record mode.
Note: It can take several seconds to overwrite or erase a scene depending on how
much memory is currently in use.
w w w . e l a t i o n l i g h t i n g . c o m
24
SHOW DESIGNER 1™ User Manual