Recalling Presets; Erasing Presets - Elation SHOW DESIGNER 1 User Manual

P R E S E T S [ c o n t i n u e d ]

RECALLING PRESETS

To turn on a preset, first select the fixtures that you want to control with the preset.
The fixtures must have been included when the preset was recorded. Next, press
the "PRESET" switch, select the page and number of the desired preset. You can
have many presets turned on at the same time as long as each preset is
controlling different channels or fixtures. If two different presets are trying to control
the same channel, the last preset that was selected will have control of the channel.
If a preset has been completely overridden by another, it will be automatically
switched off.
A fixture must be selected before the preset is turned on even if it that fixture was
included in the preset when it was recorded. This allows you to put every fixture
into a preset but use only selected ones as needed. For example you could
create a preset called "Red" that sets all color channels of every fixture to the color
red. But when calling that preset, you would only select the fixtures that you want
to be red at that time.

ERASING PRESETS

To erase an existing preset, press "RECORD" then "PRESET" then "ERASE". As when
recording a preset, all LEDs that contain a preset will light. Next select the preset to
erase. That preset name will appear in the display along with the message "Erase
This?". Press "YES" or "NO". If you press "YES" the preset will be erased. You can then
select additional presets to be erased or you can press "RECORD" again to exit
record mode.
NOTE: It can take several seconds to overwrite or erase a preset depending on
how much memory is currently in use.
w w w . e l a t i o n l i g h t i n g . c o m
27
SHOW DESIGNER 1™ User Manual