Elation SHOW DESIGNER 1 User Manual page 35

S H O W S [ c o n t i n u e d ]
RECORDING SHOWS [continued]
As you are recording a show you can go to any step by moving the cursor under
the step number and using the + or - switch or the data wheel to select a new step.
You can then edit the scene number or hold time. Pressing "ENTER" when on the
last recorded step will add an additional step to the end of the show. If you press
"ENTER" while the step number is not at the end you will advance to the next step
number the same as if you incremented the step number using the data wheel.
At any time while recording the show you can enter a name for the show. Use the
right cursor switch to move the display cursor to the right, continuing past the hold
time numbers. The screen will change to the show name on the top line and the
loop status on the bottom line. Edit the name by putting the cursor under each
character then using the + or - switch or the data wheel to change the character.
Setting the loop status lets you to program the show to loop continuously or play
once and stop.
If you continue to move the cursor to the right, a third display will appear that will
allow you to select a linked show. On playback this will automatically call a new
show after this one has finished playing. Set the link to "on" and then select a page
number and show number for the link. If you enable the link, looping will be turned
off. Likewise, if you turn looping on, the link will be turned off.
After you have finished entering the steps and making any adjustments, save the
show by selecting a page and number where you want to store it. Make sure that
the "Scene" LED is off. If you select a show number that is already lit, a message will
appear asking if you want to write over the existing show. Press "YES" or "NO".
NOTE: It can take several seconds to overwrite or erase a show depending on how
much memory is currently in use.
After you have saved the show, Show Designer 1 remains in record mode allowing
you to continue to edit the show. To exit record mode, press "RECORD", the LEDs
will stop flashing.
w w w . e l a t i o n l i g h t i n g . c o m
35
SHOW DESIGNER 1™ User Manual