Korg kronos Operation Manual page 109

Connect your guitar
1. Connect your guitar to the rear panel AUDIO INPUT
1 jack.
Press the AUDIO INPUT MIC/LINE switch inward to
select the LINE position, and set the LEVEL knob at
about the center.
Guitar
If you connect a guitar with passive pickups (i.e., a guitar
that does not contain a preamp), you will be unable to
sample it at the correct level because of the impedance
mismatch. Such guitars should be routed through a
preamp or an effect unit first, and then connected to the
KRONOS.
Setup
2. In the P0: Play/REC– Audio Input Sampling page, set
the Audio Input parameters as described below.
Use Global setting Off
– INPUT 1 –
Bus Select (IFX/Indiv.): Off
Pan: L000
Level: 127
REC Bus: Off
Note: the meter to the left of the Level fader shows the
signal level immediately after A/D conversion, before the
Level control. Changing the Level will not affect the
meter.
In the P0: Play/REC– Audio Track Mixer page, use REC
Source to select Audio Input 1 (In 1), so that the signal
Effect unit
LINE
Audio recording Recording procedure
from Audio Input 1 will be recorded directly on audio
track 1.
Audio Track 1 REC Source: Audio Input 1 (In 1)
Go to the P8: Insert Effect– Audio Routing1 page.
Set the output for Audio Track 1 as follows.
Bus Select (IFX/Indiv. Out Assign): L/R
Send1 (MFX1) and Send2 (MFX2): 000
3. In the P0: Play/REC– Preference page, set "Track
Select" to Audio Track 01.
101