Removing The Wireless Lan Module And Keyboard - Clevo W540EU Service Manual

Removing the Wireless LAN Module and Keyboard

1. Turn off the computer, turn it over, remove the battery
2. The Wireless LAN module will be visible at point
less LAN module (Figure 11a).
3. Carefully disconnect the cable
4. The Wireless LAN module
4
ribbon cable will be visible at point
5. Careful not to bend the keyboard ribbon cable
socket (Figure 11d).
7
a.
1
b.
3
2
(page 2 -
on the mainboard and keyboard ribbon cable under the Wire-
1
, and then remove the screw
2
(Figure 11c) will pop-up, and you can remove it from the computer and the keyboard
.
5
. Disconnect the keyboard ribbon cable from the locking collar
6
c.
4
d.
7
6
7
5) and the component bay cover
(Figure 11b)
3
5
4

Touchpad Cable
The touchpad cable is underneath
the keyboard cable. When disassem-
bling the mainboard, the touchpad ca-
ble must be disconnected.
Removing the Wireless LAN Module and Keyboard 2 - 15
Disassembly
Figure 11
(page 2 - 8).
Wireless LAN
Module and
Keyboard Removal
a. Locate the WLAN.
b. Disconnect the
and remove the screw.
c. The WLAN module will
pop up.
d. Disconnect the keyboard
ribbon cable from the
locking collar socket.
Note: Make sure you
reconnect the antenna
cable to the "1 + 2"
socket (Figure

4.Wireless LAN Module
• 1 Screw
cable
11b).