Clevo W540EU Service Manual page 38

Disassembly
Processor Installation Procedure
Figure 10
Processor
1. Insert the CPU
Installation
FORCE IT!), and turn the release latch
2. Remove the sticker
a. Insert the CPU. 3. Insert the heat sink
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order
wards the lock symbol.
5. Replace the CPU fan, component bay cover and tighten the screws
c. Insert the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 3 Screws
2 - 14 Removing and Installing a Processor
(Figure 10a), pay careful attention to the pin alignment, it will fit only one way (DO NOT
A
(Figure 10c) from the heat sink unit.
C
as indicated in
D
a.
A
b.
B
towards the lock symbol (Figure
B
Figure 10c.
, &
(the order as indicated on the label and
1 2 3
(page 2 -
c.
d.
D
1
2
3
Note:
Tighten the screws in the order as
indicated on the label.
10b).
Figure 10d).
12).
D
C