Laser Adjustment; Resettable Overload Switch - MasterCraft 054-8326-0 Owner's Manual

LASER ADJUSTMENT

The laser guide line should be centered in
the 0° cutting groove (1) (Fig. 13). If the
laser guide line is not correctly centered it
can be centered using a 5/64" (2 mm) slot
screwdriver.
Moving the laser line to the right
1. Turn the right laser adjustment screw
(2) counter clockwise ¼ turn.
2. Turn the left laser adjustment screw
clockwise ¼ turn.
3. Repeat steps #1 and #2 until the laser
guide line is moved to the correct
location.
Moving the laser line to the left
4. Turn the left laser adjustment screw
counter clockwise ¼ turn.
5. Turn the right laser adjustment screw
clockwise ¼ turn.
6. Repeat steps #4 and #5 until the laser
guide line is moved to the correct
location.

RESETTABLE OVERLOAD SWITCH

To avoid damaging the tool due to
overloading, the overload switch will
automatically turn the tool OFF when it
senses an overloaded condition.
When the switch turns the tool OFF, the
overload button (1) will pop out (Fig. 14).
When this condition happens, simply wait
approximately one minute and press the
overload switch button inward. Once reset,
the tool will operate normally.
ASSEMBLY AND OPERATING
23
Fig. 13
Fig. 14