Installing The Rip Guide; Vacuum Port - MasterCraft 054-8326-0 Owner's Manual

BEVEL CUTTING ANGLE– cont'd
Adjusting the sole plate angle
1. Loosen the bevel adjustment by lifting
upward on the bevel gauge
adjustment lever (1) (Fig. 8).
2. Rotate the sole plate (2) to the desired
angle as shown on the bevel gauge
(3).
3. Press downward on the bevel gauge
adjustment lever to lock the sole plate
into position.

INSTALLING THE RIP GUIDE

1. Loosen the rip guide adjusting knob
(1) (Fig. 9).
2. Slide the rip guide rod (2) into the rip
guide slot (3). Continue to slide the
guide rod across the sole plate and
into the adjusting knob slot (4) on the
opposite side of the sole plate.
3. Adjust the rip guide shoe (5) to the
correct distance from the blade and
tighten the rip guide adjusting knob.
NOTE: The rip guide may be installed from
the opposite side, but the rip guide rod
MUST engage both of the rip guide slots in
the sole plate.

VACUUM PORT

A workshop vacuum can be attached to
the vacuum port to extract much of the
dust that is created while cutting wood.
When using a workshop vacuum, pull the
vacuum port baffle tab (1) upward until the
hole in the baffle engages with the
matching pin (2) in the upper blade guard
(Fig. 10).
ASSEMBLY AND OPERATING
20
Fig. 8
Fig. 9
Fig. 10