Before Removing The Pickup Solenoid; Removing The Pickup Solenoid - Canon LBP6000 Series Service Manual

[2]
[3]
[4]
Points to note at installation
When attaching the terminal [1], make sure that the contact spring [2]
contacts as shown.
[1]
[2]

3.4.3.3 Before Removing the Pickup Solenoid

LBP6000 / LBP6000B
1) Remove the Upper Cover. (page 3-5)Reference[Removing the Upper
Cover]
2) Remove the Left Cover. (page 3-3)Reference[Removing the Left Cov-
er]
3) Remove the Right Cover. (page 3-2)Reference[Removing the Right
Cover]
4) Remove the Rear Cover. (page 3-1)Reference[Removing the Rear Cov-
er]
5) Remove the Main Controller PCB. (page 3-17)Reference[Removing the
Main Controller PCB]
[1]
[1]
[5]
F-3-105

3.4.3.4 Removing the Pickup Solenoid

LBP6000 / LBP6000B
1) Remove the terminal [1], and free the harness [3] from the Harness Guide
[2].
[1]
2) Disconnect the 4 connectors [1].
3) Free the harness [3] from the Harness Guide [2].
4) Remove the screw [5] to remove the Pickup Solenoid [4].
[3]
0025-1243
Points to Note at Installation
When installing the terminal [1], be sure that the Contact Spring [2] is in
contact with it as shown below.
[2]
F-3-106
[2]
[5]
[4]
F-3-107
Chapter 3
0025-1244
[3]
[1]
[1]
3-33