Table of Contents
Advertisement
6) Free the harness [2] from the Harness Guide [1].
[2]
[1]
7) Turn the machine [1] in the direction of the arrow.
8) Free the harness [2] from the Harness Guide [1].
[1]
9) Lift the Memory Contact Unit [1] in the direction of the arrow, and release
the claw [2] at lower side.
F-3-69
[1]
F-3-70
[2]
F-3-71
10) Remove the Memory Contact Unit [1].
- 2 Hooks [2]
- 1 Spring [3]
[1]
[3]
Points to Note at Installation
When installing the Laser Scanner Cover [1], be sure to put the Shutter
Open/Close Lever [2] through the hole [3] on the Scanner Cover.
[2]
3.1.13 Top sensor
3.1.13.1 Preparation for Removing the Paper Leading
Edge Sensor
LBP3100 / LBP3010B
1) Removing the Upper Cover (page 3-3)Reference[Removing the Upper
Cover]
2) Removing the Left Cover (page 3-2)Reference[Removing the Left Cov-
er]
3) Removing the Right Cover (page 3-2)Reference[Removing the Right
Cover]
4) Removing the Rear Cover (page 3-1)Reference[Removing the Rear
Cover]
5) Removing the Main Controller PCB (page 3-17)Reference[Removing
the Main Controller PCB]
Chapter 3
[1]
[2]
F-3-72
F-3-73
[3]
[1]
[2]
0019-4445
3-21
Advertisement
Table of Contents
