4.4.10 Document Edge Sensor
4.4.10.1 Removing the Original Placement Sensor
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Detach the front cover and open/close cover.
2) Open the ADF, remove the three screws [1], and then detach the ADF left
lower cover [2].
[1]
3) Release the claw to remove the original placement sensor [1], and then
disconnect the connector [2].
[2]
4.4.11 Registration Sensor
4.4.11.1 Removing the Registration Sensor
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the front cover and open/close cover.
2) Open the ADF, remove the three screws [1], and then detach the ADF left
lower cover [2].
[1]
3) Release the two claws [1], and then remove the grounding plate [2].
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com
[2]
F-4-30
[1]
F-4-31
[2]
F-4-32
0011-6037
[2]
[1]
4) Disconnect the connector [1], release the hook, and then remove the
registration sensor [2].
4.4.12 Separation Sensor
4.4.12.1 Removing the Separated Paper Sensor
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Detach the rear cover.
2) Release the hook, remove the separated paper sensor [1], and then
disconnect the connector [2].
0011-6036
4.4.13 Pick-up Solenoid
4.4.13.1 Removing the Pickup Solenoid
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the feed frame unit.
2) Remove the three screws [1], and then remove the drive unit [2].
F-4-33
[1]
[2]
F-4-34
[1]
[2]
F-4-35
Chapter 4
0011-5268
0011-5240
4-11