Danfoss VLT HVAC Drive FC 102 Design Manual page 132

How to Install
5 5
Illustration 5.75 Regeneration Terminal Locations - F1 and F3
Terminal Locations - Frame Size F2 and F4
Take the following position of the terminals into consideration when designing the cable access.
FASTENER TORQUE: MIO 19 Nm (14 FT -LB)
U/T1 96 V/T2 97 W/T3 98
1 Front Side
2 Left Side
Illustration 5.76 Terminal Locations - Inverter Cabinet - F2 and F4. Gland Plate is 42 mm below .0 Level.
130
Design Guide
1
FASTENER TORQUE: MIO 19 Nm (14 FT -LB) FASTENER TORQUE: MIO 19 Nm (14 FT -LB)
U/T1 96 V/T2 97 W/T3 98 U/T1 96 V/T2 97 W/T3 98
Danfoss A/S © Rev. 05/2014 All rights reserved.
DC '-'
1739.1
805.0
765.0
1694.1
DC '+'
1654.1
710.0
2
6
3 Right Side
4 Ground bar
3
4
308.3 [12.14]
253.1 [9.96]
180.3 [7.10]
5
0.0 [0.00]
4
MG16C202