MSA Chillgard RT Instruction Manual page 5

9. Properly vent the exhaust of the Chillgard RT System to a safe
area. Improper venting of the exhaust may cause serious personal
injury or death.
10. Ensure the gas sample to the system is clean and non-condensing.
Install end-of-line filters in all sample inlet lines.
11. Avoid any installation where condensation may form. Condensation
may possibly clog or block the sampling line; this will prevent the
instrument from receiving new or fresh gas samples from the area
being monitored.
12. The Chillgard RT Refrigerant Monitor must be installed, located
and operated in accordance to all applicable codes. These codes
include, but are not limited to, the National Fire Prevention Code
and National Electric Code.
13. The Chillgard RT Relay Module must be connected to proper main
voltages. Connection of improper voltages will cause the unit to
fail. The Chillgard RT Relay Module uses the same electrical
ground as the RT Monitor.
14. Protect the Chillgard RT Relay Module from vibration and heating;
otherwise, improper operation may result, which can result in
personal injury or death.
15. Do not exceed the relay contact ratings listed in Appendix B,
TABLE B-1 Otherwise, relay operation may fail, which can result in
personal injury or death.
Failure to comply with the above warnings can result in
serious personal injury or death.
1. Do not attempt to modify or adjust the sensing element.
CAUTION
iii