Printronix T600 Administrator's Manual page 51

Print Speed
Tear Off
Print mode
Print Width
List Fonts
List Images
List Formats
List Setup
Control Prefix
Format Prefix
Delimiter Char
Media Power Up
Head Close
Label Top
Left Position
Reprint Mode
Use this item to setup print speed. The each increase or decrease is 1
ips. Available setting is from 2 to 6.
This item is used to fine tune media stop location. Available setting
value is from "+" to "-" or "0" to "9".
This item is used to set the print mode. There are 3 modes as below,
Printer Mode Description
Next label top of form is aligned to the print
Tear Off
head burn line location.
Peeler Off Enable the label peel off mode.
Cutter Enable the label cutter mode
This item is used to set print width. The available value is from "0" to
"9".
This feature is used to print current printer available fonts list to the
label. The fonts stored in the printer's DRAM, Flash or optional
memory card.
This feature is used to print current printer available images list to the
label. The images stored in the printer's DRAM, Flash or optional
memory card.
This feature is used to print current printer available formats list to the
label. The formats stored in the printer's DRAM, Flash or optional
memory card.
This feature is used to print current printer configuration to the label.
This feature is used to set control prefix character.
This feature is used to set format prefix character.
This feature is used to set delimiter character.
This option is used to set the action of the media when you turn on the
printer.
Selections Description
Feed Printer will advance one label
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length Printer determine length and feed label
No Motion Printer will not move media
This option is used to set the action of the media when you close the
print head.
Selections Description
Feed Printer will advance one label
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length Printer determine length and feed label
No Motion Printer will not move media
This option is used to adjust print position vertically on the label. The
range is -120 to +120 dots.
This option is used to adjust print position horizontally on the label. The
range is -9999 to +9999 dots.
When reprint mode is enabled, you can reprint the last label printer by
- 43 -
6 (203dpi)
4 (300dpi)
+000
Tear Off
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
No
Motion
No
Motion
0
+0000
Disabled
P180043-001_A