Set Gap Sensor As Media Sensor And Calibrate The Gap Sensor - Printronix T600 Administrator's Manual

5.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns red/amber after 5 green/amber blinks. (Any red/amber will do during
the 5 blinks).

The LED will be changed as following:
Green  amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5 blinks) 
red/amber (5 blinks)  solid green
- 36
Release button
P180043-001_A