Tait TM8200 Installation And Operation Manual page 19

Table 1.4 CCTM commands in the transmitter category (part 1)
Command
Transmitter category
33 – Transmit mode
Sets the radio in the transmit mode
47 – Temperature
Reads the temperature in the
vicinity of the PAs
114 – Transmitter power
Sets or reads the transmitter power
setting (compare command 326)
304 – Driver bias
Sets or reads the clamp current at
the gate of the PA driver
318 – Forward power
Reads the forward-power level
319 – Reverse power
Reads the reverse-power level
326 – Transmitter power
Sets the power level of the
transmitter
19 General Information
Entry at keyboard
33
47
114 (to read value)
114 x (to set value)
where x is the required power
setting (an integer from 0 to 1023)
304 (to read value)
304 x (to set value)
where x is the required DAC value
of the clamp current
(an integer from 0 to 255)
318
319
326 x
where x specifies the level
(0=off, 1=very low, 2=low,
3=medium, 4=high, 5=maximum)
Usage
Response on screen
None
x
y
where x is the ADC value of the
tem-perature (an integer from 0 to
1023) and y is the corresponding
voltage in millivolts (a value from 0
to 1200 mV)
x
where x is the current power
setting (an integer from 0 to 1023)
None
x
where x is the DAC value of the
clamp current (an integer from 0 to
255)
None
x
where x is the voltage in millivolts
corresponding to the power level
(a value from 0 to 1100 mV)
x
where x is the voltage in millivolts
corresponding to the power level
(a value from 0 to 1100 mV)
None
August 2004© Tait Electronics Ltd
Tuneup