Connecting The Ethernet And Power Cables - Cisco Aironet 1130AG Series Hardware Installation Manual

Chapter 2 Installing the Access Point

Connecting the Ethernet and Power Cables

The access point receives power through the Ethernet cable or an external power module.
shows the power options for the access point.
Figure 2-13 Access Point Power Options
SYST 1
RPS 2
STAT
UTIL DUPLX
SPEED
MODE
Warning This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or an
IEC60950 compliant limited power source.
The access point supports the following power sources:
•
•
Some switches and patch panels might not provide enough power to operate the access point when
Note
configured with both 2.4-GHz and 5-GHz radios. On power-up if the access point is unable to determine
that the power source can supply sufficient power, the access point automatically deactivates both radios
to prevent an over-current condition. The access point also activates a Status LED low power error
indication and creates an error log entry (refer to the
page 6-2
OL-6226-01
C I S C O C O N F I D E N T I A L -
Option 1
Switch with
inline power
3
4 5
6
7
8 10Base -T
9 10 / 100Bas
11 e-TX
12
13 14
15
16
17
18 19 Cataly st 2950
20 SERIES
21
22 23
24 100Bas e-FX
23
24
Access Point
Power module (supplied)
Inline power:
Cisco Aironet Power Injector (AIR-PWRINJ3 or AIR-PWRINJ-FIB)
–
An inline power capable switch, such as the Cisco Catalyst 3524 PWR XL, 3560-48PS,
–
3570-48PS, 4500 with 802.3AF PoE module, or the 6500 with 802.3AF PoE module
Other inline power switches supporting the IEEE 802.3af inline power standard
–
and the "Low Power Condition" section on page
D r a f t 2
- need new picture with Ajax
Option 2
Switch
(without inline power)
SYST 1
RPS 2
3
4 5
STAT UTIL DUPLX 6
SPEED 7
8 10Base -T
MODE 9 10 / 100Bas
11 e-TX
12
13 14
15
16
17
18 19 Cataly st 2950
20
21 SERIES
22
23 24 100Bas e-FX
23
24
Inline Power
Patch Panel
SYST
RPS
STAT UTIL
DUPLX SPEED
MODE
"Checking the Access Point LEDs" section on
6-5).
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

Connecting the Ethernet and Power Cables

Figure 2-13
Option 3
Switch
(without inline power)
SYST 1
RPS 2
3 4
STAT 5
UTIL DUPLX SPEED 6
7 8
9 10Base -T
MODE 10 / 100Bas e-TX
11
12 13
14
15
16
17 18 Cataly st 2950
19
20 SERIES
21 22
23 100Bas e-FX
24
23
24
Power injector
Power
cord
Universal
power supply
Option 4
2-17