Mounting On A Horizontal Or Vertical Surface - Cisco Aironet 1130AG Series Hardware Installation Manual

Mounting the Access Point

Mounting on a Horizontal or Vertical Surface

Follow these steps to mount the access point on a horizontal or vertical surface:
Step 1 Use the mounting plate as a template to mark the locations of the two mounting holes (labled with an X)
and the location of the cable access hole (see
Figure 2-7
1
2
Drill one of the following sized holes at the X mounting hole locations you marked:
Step 2
•
•
Insert the wall anchors into the mounting holes if you are using them.
Step 3
If needed, drill or cut a cable access hole large enough for the access point cables and pull the cables
Step 4
through the access hole until you have about 1 foot of exposed cables protruding from the hole.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-10
C I S C O C O N F I D E N T I A L -
Mounting Plate
Keyhole clip
Cable access hole location
3/16 in. (4.7 mm) if you are using the supplied wall anchors
1/8 in. (6.3 mm) if you are not using wall anchors
Chapter 2
D r a f t 2
Figure 2-7).
3 X mounting hole
4 Padlock hole
Installing the Access Point
OL-6226-01