Assigning Basic Settings - Cisco Aironet 1130AG Series Hardware Installation Manual

Assigning Basic Settings

Tip
Figure 3-1
Figure 3-1
1
Note
Set up a terminal emulator on your PC to communicate with the access point. Use the following settings
Step 3
for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Assigning Basic Settings

After you determine or assign the access point's IP address, you can browse to the access point's Express
Setup page and perform an initial configuration:
Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape
Step 1
Navigator (version 4.x).
Enter the access point's IP address in the browser address line and press Enter. An Enter Network
Step 2
Password screen appears.
Press Tab to bypass the Username field and advance to the Password field.
Step 3
Enter the case-sensitive password Cisco and press Enter. The Summary Status page appears.
Step 4
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-4
C I S C O C O N F I D E N T I A L -
If your serial cable enters from the lower cable bay area, you should loop the cable as shown in
Figure 2-14.
shows the console port location.
Console Port Location
Console port
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
http://www.cisco.com/go/marketplace
Chapter 3 Configuring the Access Point for the First Time
D r a f t 2
to order a serial cable.
OL-6226-01