Attaching The Leader Pin To The Tape - IBM TS3500 Introduction And Planning Manual

1
Figure 48. Attaching the leader pin to the tape
12. Close the pivot arm 4 of the leader pin attach tool by swinging it over the
13. Swing the pivot arm open and trim the excess tape 5 so that it is flush with
14. Use your fingers to remove the leader pin from the cavity 3 in the leader
15. Use the cartridge manual rewind tool to wind the tape back into the cartridge
16. Remove the rewind tool.
17. Remove the leader pin attach tool by lifting its end up and away from the
sides of the pin.
6
5
leader pin so that the C-clip snaps onto the pin and the tape.
the reattached leader pin 6 .
pin attach tool.
(wind the tape clockwise). Ensure that the leader pin is latched by the
pin-retaining spring clips on each end of the leader pin.
cartridge.
2
4
3
Chapter 4. Using Ultrium media
165