Light Kit Assembly. Pgs - Litex E-BT52ABZC5C1S Installation Manual

9. Light Kit Assembly.
Remove 1 screw from fitter plate on
underside of motor and partially loosen the
other 2 screws. Align slotted holes in center
of switch housing with loosened screws in
fitter plate, allowing the male plug from
motor housing to come through hole in
middle of switch housing. Twist switch
housing to lock. Re-insert screw that was
previously removed and securely tighten all
3 screws with Phillips screwdriver.
Remove 1 screw from post located in
middle of switch housing plate and
partially loosen the other 2 screws. Connect
male plug (large) from motor housing to
female plug (large) from the light kit fitter.
Connect male plug (small) from the switch
housing plate to female plug (small) from
the light kit fitter. Align slotted holes in
light kit fitter with loosened screws in
switch housing plate. Twist light kit fitter to
lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
Remove finial, finial plate and threaded
washer from light kit fitter.
Install 3 candelabra base 40 watt max. bulbs
(included).
Important: When replacing bulbs, please
allow bulbs and glass shade to cool down
before touching them.
["Light Kit Assembly" continued on next
page.
motor
housing
fitter plate
switch housing
male plug
(large)
motor
housing
switch housing
male plug
(large)
female plug
(large)
light kit fitter
threaded washer
finial plate
finial
page 7
screw
screw
male plug
screw
(small)
female plug
(small)
screw
bulb