Fan Assembly. Pgs - Litex E-BT52ABZC5C1S Installation Manual

5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 6in. downrod provided to use with an
extended downrod (sold separately). [If you
wish to use the 6in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Loosen yoke set screws and nuts and remove
pin and clip at top of motor housing. Slide
downrod through canopy, canopy cover and
yoke cover. [Note: Canopy cover must be
turned with the non-slotted side toward the
motor housing.]
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke
and re-insert pin and clip that were just
removed. Tighten yoke set screws and nuts
securely. Lower yoke cover to motor housing.
Remove electrical tape from electrical wiring
and thread one wire through each hole in the
weatherproof hanging ball cover. Pull
weatherproof hanging ball cover down
securely over hanging ball (on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
electrical wiring
downrod
yoke cover
pin
page 4
set screw hole
stop pin
hanging ball
B
weatherproof hanging
ball cover
canopy
canopy cover
yoke set screw
motor
housing
clip