Preparation And Marking The Boundaries Of The Work Areas - AMBROGIO 6060BA0 User Manual

PREPARATION AND MARKING THE BOUNDARIES OF THE WORK AREAS

preparation of the lawn to be mowed
1. Make sure that the lawn to mow is even and does not contain holes, stones or other obstacles. Otherwise, prepare the lawn
EN
by filling in any holes and removing any obstacles. If some obstacles cannot be removed, it is necessary to properly define
and protect the interested areas.
2. Check that all the areas of the lawn do not exceed the allowable slopes (see "Technical Specifications").
The sensors, which recognise the presence of the grassy surface, allow the robot to move freely inside the lawn. The lawn must
be suitably checked and adjusted so that the robot has enough space for recognising when there is no grass. Carefully follow
the below points for the correct and safe use of the robot.
WALL
higher than
9 cm. / 3,5 "
Types of boundaries/protections that can be used for correctly defining the limits of the robot's work area.
Pavement
The robot requires at least 25 cm (9.84 ") without any grass for
it to stop safely and change direction. For lawns with paths or
curbs, they must be at least 25 cm (9.84 ") wide. Any curbs that
are less than 25 cm (9.84 ") side, must be protected with paving
or arches in the ground, as shown in the figure, so that the robot
impacts with them.
The robot with the curb drop-off sensor installed needs 10 cm
(4,00 ") without any grass
Wall
Perimeter wall, which defines the boundary of the work area at
a height above 9 cm. (3.54 "). If the walls are shorter, protect the
area with arches or adequate paving.
User's manual
HEDGING
.
SMALL ARCHES
With the curb drop-off sensor installed,
Minimum width 10 cm (4,00 ")
10
OK
PAVING
wider than 25 cm. / 9,8 "
With the curb drop-off sensor installed,
Minimum width 10 cm / 4.0 "
OK
minum width of 25 cm
(9,80 ")
OK
minimum high
9 cm. (3,50 ")