The figure shows the correct mounting position.
● Direction of flow: Make sure that the blades
of the housing.
● Run the power supply cable
loop as shown in the illustration.
7.4.7
Removing and installing the device fan
Requirement
● The device is opened.
Procedure
Removal
1.
SIMATIC IPC627D/827D
Operating Instructions, 09/2014, A5E32990859-AB
Remove the two screws
remove the air guide pulling it
up vertically.
①
of the power supply fan are on the outside
②
along the housing edge and fasten any excess cable as
①
and
Device maintenance and repair
7.4 Removing and installing hardware
87