Removing And Installing Expansion Cards With 827D - Siemens SIMATIC IPC627D Operating Instructions Manual

Expanding and assigning parameters to the device
6.3 Expansion cards
2. Cut off the protruding part of
Notes on the allocation of resources
The slots for the expansion cards come with exclusive interrupts. The assignment of the PCI
IRQ line to the PCI slot is explained in the chapter "Bus board (Page 126)".
6.3.3

Removing and installing expansion cards with 827D

Requirement
● The device is opened.
Procedure
1. Remove the two fastening
screws
ule bracket
2. Remove the slot cover
the intended slot.
3. Insert the expansion card
the intended slot.
4. Install the module bracket.
5. Fasten the slot cover
expansion card.
6. Insert the slider.
64
the slider element.
Use a knife to apply a cut on
the slider at the upper edge
of the bracket and then break
this section off. Cut off the
excess length with a diagonal
cutter.
②
and remove the mod-
①
.
④
④
from
③
into
of the
SIMATIC IPC627D/827D
Operating Instructions, 09/2014, A5E32990859-AB