Fans, ventilation duct, crosspiece
Installing the front fan
Fig. 13: Installing the front fan
•
Connect the fan cable.(refer to
•
Insert the fan into the housing in the direction of the arrow (1) so that the lower edge of
the fan is flush with the bottom of the device.
•
Slightly pull back the green expansion rivet (2) until the tip of the expansion rivet is no
longer spread.
•
Press the green expansion rivet (2) into the hole on the housing.
•
Secure the fan by pressing the green expansion rivet (2) into the housing until the tip of
the expansion rivet is spread again.
•
Close the front panel
•
Close the housing
Siemens
Medical Solutions
NOTE
Make sure that the power supply cable is not pinched when
doing so.
(Closing the front panel / p.
(Closing the housing / p.
TD00-400.841.40.02.02
01.08
(Fig. 9 / p. 14)
"Front fan")).
13).
10).
Page 17 of 52
CS SD SP/CO
17
0
CELSIUS M450/440