Commission Number; 6.13.2.10 Operators Pass; 6.13.2.11 Pipe Prepared? Display; Subcontractor - FRIATEC FRIAMAT Prime Operating Instructions Manual

EN
6.13.2.5

Subcontractor

Text entries can be activated or deactivated in the "SUBCONTRACTOR" sub-
menu. Also, the selected settings can be locked against user access.
6.13.2.6 GPS Data
Coordinate entries can be activated or deactivated in the "GPS DATA" sub-
menu. Also, the selected settings can be locked against user access.
6.13.2.7 Seam number
Entering seam numbers can be activated or deactivated in the
"SEAM NUMBER" submenu. Also, the selected settings can be locked
against user access.
6.13.2.8 Serial number
In the "SERIAL NUMBER" submenu, you can decide whether the serial num-
ber (assigned by the device) is assigned to the commission number (within the
commission number, beginning with "1") or independently of it, i.e. consecu-
tively.
6.13.2.9

Commission number

Work with commission numbers can be activated or deactivated in the
" Commission number" submenu. In addition, you can specify whether the
commission number is to be entered every time the device is switched ON
and/or before each fusion. Also, the selected settings can be locked against
user access.

6.13.2.10 Operators pass

Work with an operator pass can be activated or deactivated in the
" OPERATOR PASS" submenu. In addition, when an operator pass has been
activated, you can deactivate the default setting that the operator pass must
be read in again on a change of date (i.e., in activated mode, the device is first
locked the next day until an operator pass has been read in).
In addition, you can also specify whether the operator pass is to be entered
every time the device is switched ON and/or before each fusion. Also, the se-
lected settings can be locked against user access.

6.13.2.11 Pipe Prepared? Display

In the "PIPE PREPARED? DISPLAY", you can activate or deactivate the
warning shown before fusion starts.
44