Sources Of Danger; Mains Operation - FRIATEC FRIAMAT Prime Operating Instructions Manual

EN
2.3

Sources of danger

WARNING!
Electric shock from live parts! Danger of death!
- Never leave the FRIAMAT fusion unit unattended.
- Immediately replace damaged housings, connecting lines, and extension
cables. Stop using the FRIAMAT fusion unit.
- Before all care and maintenance work, pull out the plug connecting the
equipment.
- Maintenance and repair work must be performed by authorised FRIATEC
service stations only.
- Supply FRIAMAT fusion units only with the operating voltage specified on
the ratings plate.
- Fit a residual current protective device (RCD) when this is prescribed.
- Do not remove or otherwise put safety installations out of operation.
- Immediately eliminate identified defects.
WARNING!
Danger of fire and explosion from highly flammable materials and
potentially explosive atmospheres!
- Keep away from flammable liquids and gases.
- Do not use in potentially explosive atmospheres (e.g. in areas where
flammable gases, solvent vapours, or ignitable dusts can accumulate).
- Never leave the FRIAMAT fusion unit unattended.
2.4

Mains operation

Out of doors (building sites), power outlets must be fitted with residual
current protective devices (RCDs). The regulations governing RCDs must be
observed here.
NOTE
Before commencing fusion, check the input voltage. The FRIAMAT fusion unit
is designed for an input voltage range of 190–250 V!
8