Table of Contents
Advertisement
Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to
5 inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and raise
the mower deck to the T
127 mm or 5 inch cutting-height position) as shown
in
Figure
30.
3. To adjust, remove the pin from the height-of-cut
bracket
(Figure
30).
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
30).
5. Push on the deck lift, pull up on the transport lock
knob, and slowly lower the mower deck.
Figure 30
1. Deck-lift pedal
2. Height-of-cut holes
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and engage the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
position.
OCK
position (also the
RANSPORT
(Figure
3. Height-of-cut pin
4. Transport lock knob
-
position,
EUTRAL
LOCK
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Flange nut
2. Bolt
g036745
3. Spacer
Stopping the Machine
To stop the machine, move the motion-control levers to
neutral and then to the N
the blade-control switch (PTO), and turn the ignition key to
the O
position.
FF
Engage the parking brake when you leave the machine; refer
to
Engaging the Parking Brake (page
from the ignition switch.
26
Figure 31
4. Flange nut
5. Bolt
Figure 32
4. Anti-scalp roller
5. Bushing
-
position, disengage
EUTRAL
LOCK
20). Remove the key
g192815
g036848
Advertisement
Table of Contents
