Operating The Ignition Switch; Starting And Shutting Off The Engine - Toro 74447TE Operator's Manual

1
2
Figure 21
1. O position
N
Operating the Ignition
Switch
1. Turn the ignition key to the S
Note: When the engine starts, release the key.
Important: Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, wait 15 seconds between attempts. Failure to
follow these instructions can burn out the starter
motor.
Note: You may need multiple attempts to start the
engine when you start it the first time after the fuel
system has been without fuel completely.
Figure 22
2. Turn the ignition key to the S
the engine.
G008959
g008959
2. O position
FF
position (Figure
TART
G008947
g008947
position to shut off
TOP
Starting and Shutting Off
the Engine
Starting the Engine
1. Raise the roll bar up and lock into place, sit on the seat,
and fasten the seat belt.
2. Move the motion controls to the N
position.
3. Engage the parking brake; refer to
Parking Brake (page
4. Move the blade-control switch (PTO) to the O
position (Figure
5. Move the throttle lever midway between the S
F positions.
AST
22).
6. Turn the ignition key to the S
Note: When the engines starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15-second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
22
EUTRAL
Engaging the
20).
23).
Figure 23
position
TART
-
LOCK
FF
and
LOW
g036838
g036838
(Figure 24).